CrestlineCoach
Page10
2003
RemountManual
6.0
REMOUNT
As per the diagrams to follow, please note the location of the flat mounting plates. The outside to
outside dimension of the plates is 42 inches. Please also note the location of the current bodypuck
mounting locations. If the new chassis body puck locations are not in the indicated positions, new
1 3/8" diameter holes will have to be drilled. Consult the appropriate body builders book and or
guidelines for further information.
Lower thebodyonto thenew chassis. Pleasewatch for cableor hose interference.
Check to ensure that the flat mounting plates attached to the underside of the floor frame are
centred over the factory chassis frame rails and that the bolt hole locations are consistent with the
factory chassis body puck locations. Also check that the frame rails are close to the end of the
modular bodyat the rear.
Secure thebody to chassis connections as per suggestedO.E.M. guidelines.
Bolt the cab and edge seal to the front of themodular body.
Reconnect the conversionharness and associated electrical.
Reconnect the air conditioningandheater hoses.
Reinstall anyheat shields that arenecessary.
Make the appropriate factory electrical connections such that the required exterior lighting is
activatedwith the chassis lights (for example, clearance lights andbrake lights).
Replace theground strap(s).
Install new fuel filler as requiredby the situation.
Reattach the rear bumper andmud flaps.
Use the attached INSPECTION FORMS as a guideline to completing the fine details of the
remount process.
